Note that if no reply is received to a re-optimization PREQ, the existing path is kept anyway (until it timeouts itself)Īctive-port-type ( read-only: wireless | WDS | ethernet-mesh | ethernet-bridge | ethernet-mixed Default: ) Turning on this setting is useful if the network topology is changing often. Whether to send out periodic PREQ messages asking for known MAC addresses. Whether this interface is a portal in the mesh network How long to wait before propagating a RANN message. Hwmp-rann-propagation-delay ( number Default: 0.5) Lifetime for routes created from received RANN messages How often to send out HWMP+ RANN messages Note that for subsequent PREQs the waiting time is increased exponentially How long to wait for a response to the first PREQ message. Hwmp-preq-waiting-time ( time Default: 4s) How many times to retry a route discovery to a specific MAC address before the address is considered unreachable Useful only when hwmp-preq-destination-only is disabled Whether intermediate nodes should forward HWMP+ PREQ message after responding to it. Hwmp-preq-reply-and-forward ( boolean Default: yes) Whether the only destination can respond to HWMP+ PREQ message Hwmp-preq-destination-only ( boolean Default: yes) Lifetime for routes created from received PREP or PREQ messages Maximum hop count for generated routing protocol packets after an HWMP+ packet is forwarded "hoplimit" times, it is dropped Hwmp-default-hoplimit ( integer: 1.255 Default: ) If disabled, then the value from admin-mac will be used as the MAC address of the mesh interface else address of some port will be used if ports are present Admin-mac ( MAC address Default: 00:00:00:00:00:00)Īdministratively assigned MAC address, used when the auto-mac setting is disabledĪrp ( disabled | enabled | proxy-arp | reply-only Default: enabled)
0 kommentar(er)
